Bosch DLA-AIOU0 Guía De Instalación Rápida página 21

1200 Series/4-bay IP Video Storage System
The Bosch DLA disk arrays are based on Microsoft Storage Server 2008. Microsoft Windows
Storage Server 2008 operating systems provide a user interface for initial server
configuration, unified storage appliance management, simplified setup and management of
storage and shared folders, and support for Microsoft iSCSI Software Target.
It is specially tuned to provide optimal performance for network-attached storage. Windows
Storage Server 2008 provides significant enhancements in share and storage management
scenarios, as well as integration of storage appliance management components and
functionality.
3.2 Setup Instruction
All Bosch DLA Series disk arrays are preconfigured with a default IP address and with default
iSCSI settings.
–
–
–
–
Detailed information, such as data sheets and user manuals, are available on the Bosch web
site www.boschsecurity.com under Product Catalog > CCTV > IP Video > Disk Arrays.
Default iSCSI settings are optimized for use with VRM. Only an experienced storage
administrator should make changes to these settings. Changing the default configuration is
only required either if VRM is not used or if the default settings are not appropriate for
another Bosch iSCSI application.
3.3 Setting the IP Address
The default IP address may be changed by either of two ways.
3.3.1 Remote Desktop Connection
1.
2.
3.
4.
Bosch Sicherheitssysteme GmbH
IP Address: 10.10.10.10 (1st port) and 10.10.10.11 (2nd port)
Net mask: 255.255.255.0
User: Administrator
Password: WSS4Bosch
Connect the system to your network through port 1 or port 2 and start up the system.
The system comes with the Remote Desktop Connection enabled. Log on to an
appropriate Client system either with Windows XP, Windows Vista or Windows 7
installed (Client hardware and software is not part of the shipment) with an IP Address in
the same network, e.g. 10.10.10.12 (net mask: 255.255.255.0).
Open the Remote Desktop Connection on your client system. In the Computer box,
enter the IP Address of the disk array you want to connect to.
Default IP Address: 10.10.10.10 (port 1)
Click Connect, press Ctrl+Alt+Del (if shown), then type the default password
WSS4Bosch once the disk array login window is displayed.
On first login the desktop default settings are applied. This will take a few seconds and
the system will reboot. After system reboot, log on again and the Bosch VRM Appliance
Quick Installation Guide
System Setup – First Steps | en
- | V1 | 2011.03
21