Teac PD-505T Manual Del Usuario página 10

Connections
V
After all connections are complete, connect the power cord's plug to the AC wall outlet.
o Read the instructions of each device that you intend to use with this unit.
o Do not bundle connecting cables with power cords. Doing so could cause noise.
o Connect all plugs completely.
CLOCK OUT
Device that outputs
clock signal
A
UPDATE (maintenance) port
This is used for maintenance. Do not connect anything to this
port unless instructed to do so by our service department.
B
CLOCK sync input (10MHz IN) connector
Use this connector to input 10MHz clock synchronization signals
(page 23).
Use a commercially available BNC coaxial cable for
connection.
C
COAXIAL/OPTICAL digital audio output connectors
Use these to output digital audio. Connect digital audio input
connectors of audio devices here.
Use commercially-available RCA coaxial digital cables or
rectangular optical digital cables for connection.
10
Optical digital input
DIGITAL IN
(OPTICAL)
Digital audio
input device
Coaxial digital input
DIGITAL IN
(COAXIAL)
Digital audio
input device
D
Power inlet (~IN)
Connect the supplied power cord here.
After all other connections are complete, connect the
power cord's plug to a wall outlet.
V
Do not use any power cord other than the one
included with this unit. Use of other power cords
could result in fire or electric shock.
V
Disconnect the power plug from the outlet if you
will not use the unit for a long time.
c
Wall outlet