Publicidad
⑦
⑩
②
10
⑧
⑨
⑪
⑫
①
③
English
To replace, position the shield on the base plate so that the lower part of the sliding
slot of the shield is over the spring clip of the base plate and the brass stud is in the
red hole of the base plate ⑦. Press the shield onto the spring clip, and then fully
raise the shield until the brass stud falls into the sliding slot of the base plate ⑧ &
⑨. Position top hook on the backside of the side pod into the top tab of base plate
⑩ , align the side pod with the recess of the helmet shell and push the lower part of
the side pod down firmly until it clicks into place and is fully captured by the base
plate ⑪. Repeat for the other side. Work the shield up and down to confirm proper
operation ⑫.
TO REMOVE/REPLACE BASE PLATES
.
To remove, first remove the shield. Remove two screws from each base plate with a
flat blade screwdriver or a coin ①. Remove plates from helmet shell. Note the right
and left base plate for proper reinstallation.
To replace, place base plate over the threaded screw receptacles in the helmet. Install
the two screws through each base plate into the helmet finger tight ②, do not fully
tighten. Install shield, lower the shield to fully closed position and press the front
center of the shield to bring it against the eyeport trim. While still pushing on the
shield to keep a tight seal against the eyeport trim, tighten the base plate screws ③
– but be careful not to overtighten, as the screws may break. It may be necessary to
do one side at a time, with a smoothing pressure from the shield center toward each
base plate and tightening one and then the other for best results.
Publicidad
