Dometic HiPro Apollo, Evolution
Problem
Frost formation in the minibar com-
partment
Interior lighting is not working
10 Disposal
WARNING! Fire hazard
• The refrigerant is highly flammable. Do not open or damage the refrigerant circuit.
• The insulation of the device contains an insulating gas (see data plate). Do not damage the insula-
tion.
Recycling packaging material: Place the packaging material in the appropriate recycling waste bins wher-
ever possible.
Recycling products with non-replaceable batteries, rechargeable batteries or light sources:
• Dispose the product in accordance with all applicable regulations.
• The product can be disposed free of charge.
11 Warranty
Refer to the sections below for information about warranty and warranty support in the US, Canada, and all other re-
gions
Possible cause
Door of minibar is not closed with a
tight seal.
Minibar recently filled.
For versions with absorber cool-
ing: The input voltage is too low or
too high.
Door of minibar is not closed with a
tight seal.
Power plug is not plugged in.
Interior lighting is defective.
Surface of infrared door sensor is cov-
ered by condensation.
Suggested remedy
Check distances (see Installation Man-
ual).
Contact an authorized service
agent.
Service agent only: Replace
door seal
Check cooling again after 5 h ... 6 h.
Check input voltage.
Check distances (see Installation Man-
ual).
Contact an authorized service
agent.
Service agent only: Replace
door seal
Insert the power plug into the socket.
Contact an authorized service
agent.
Service agent only: Change
interior lighting
Clean the surface of the infrared door
sensor.
EN
15