Sauder 102795 Instrucciones De Montaje página 12

Step 9
Carefully turn your unit over onto its front edges. Unfold the
å
LARGE BACK (CC) and lay it over your unit.
Make equal margins along all four edges of the LARGE
å
BACK (CC). Push on opposite corners of your unit if needed
to make it "square".
Fasten the two sides and top edge of the LARGE BACK (CC)
å
to your unit using the NAILS (U).
NOTE: The lower edge will be nailed when the BACK (DD)
å
overlaps the LARGE BACK.
Fasten the BACK (DD) to your unit using the NAILS (U).
å
NOTE: Be sure to tap NAILS into the holes in the overlapping
å
edges of the BACKS that line up over the SHELF (BB).
NOTE: Perforations have been provided for access through
å
the BACKS. Carefully cut out the holes needed.
These holes must line
up over the SHELF (BB).
Page 12
CC
DD
102795
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(37 used in this step)
This perforation is
farther from this edge.
DD
NOTE: The lower BACK (DD)
overlaps the LARGE BACK (CC).
www.sauder.com/services
U
CC