Sauder 102795 Instrucciones De Montaje página 14

Step 11
With a scissors, cut out the rectangular spacer at the top of this page and
å
lay it on the corner of an ADJUSTABLE SHELF (C) as shown in the enlarged
diagram.
Fasten an ADJUSTABLE SHELF MOLDING (G) to an ADJUSTABLE
å
SHELF (C). Use three BLACK 9/16" LARGE HEAD SCREWS (T) through the
BRACKETS and into the groove in the MOLDING.
NOTE: Be sure the notched edge of the MOLDING fi ts around the
å
ADJUSTABLE SHELF.
NOTE: There are no pre-drilled holes in the ADJUSTABLE SHELF
å
MOLDING (G). The SCREWS will tighten into the groove.
Repeat this step for the remaining ADJUSTABLE SHELVES (C).
å
BLACK 9/16" LARGE HEAD SCREW
(9 used in this step)
Page 14
Cut out this rectangle to use as a
G
C
T
"spacer"
1-11/16"
102795
G
L
C
www.sauder.com/services