Cutting, Sawing And Scraping - Makita DTM51 Manual De Instrucciones

As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
To remove the holder bolt, follow the installation
procedures in reverse.
014554
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
OPERATION
WARNING:
Before starting the tool and during operation, keep
•
your hand and face away from the application tool.
CAUTION:
Do not apply excessive load to the tool which may
•
cause a motor lock and stop the tool.

Cutting, sawing and scraping

CAUTION:
Do not move on the tool forcibly in the direction
•
(eg. towards either side) of tool application with no
cutting edge. It may damage the tool.
014559
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
1. Adapter
1
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 4 - 6.
Remove sawdust by drawing the tool adequately.
•
It increases work efficiency.
The round saw is recommended for cutting long
•
straight line.
Sanding
CAUTION:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding
•
paper without grit.
014560
Apply a sanding paper on the workpiece.
NOTE:
Using a test
•
recommendable to determine a correct orbital
stroke rate suitable for your work.
Use a sanding paper with the same grit until
•
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
8
material sample to try is