Mannesmann 92575 Instrucciones De Uso página 7

Device Description (Fig. 1)
1. operating switch
rotational speed regulator
2.
3. locking button
4. clamping nut
collet chuck
5.
Technical Information
voltage
capacity
neutral rotational speed
sound pressure level (LPA)
(uncertainty K = 3 dB)
sound power level (LWA)
(uncertainty K = 3 dB)
vibration specifications
(uncertainty K = 1,5 m/s²)
protection class
Wear safety glasses and ear protection at
all times when operating the machine!
Installing the Attachments
Before installing or changing the
1.
attachments, the device must be
disconnected from the power supply in
order to prevent it from switching on
unexpectedly.
In order to disengage the clamping nut,
2.
press the locking button and turn the
chuck until the locking button snaps into
place and the motor shaft is locked.
Place the attachment's shaft in the collet
3.
chuck.
4. Let the motor shaft lock into place while
pressing the locking button and tighten the
clamping nut tight until the attachment is
secured.
In order to replace the collet chuck, the
clamping nut must first be removed.
230V~ / 50 Hz
130 Watts
-1
8,000-30,000 min
73 dB(A)
84 dB(A)
2.02 m/s²
/ II
GB - 8
• Place the new collet chuck in the shaft's
opening and then replace the clamping
nut.
• Use only the original collet chucks that are
provided with the device.
• Use only the collet chucks that correspond
to the shaft diameter of the attachment.
• Do not try to force an attachment with a
shaft that is too thick into the collet chuck.
The attachment should slide easily into the
collet chuck and be tightly secured.
Checking the Attachments
•
Before beginning to work, check whether
the attachment you are using is damaged.
Damaged attachments should never be
used, as they present a danger of injury.
•
After installing the attachment, first run the
machine at a low rotational speed and
check whether the rotation is true.
•
Increase the rotational speed to the
highest level and check whether the
attachment's rotation is irregular or if you
feel strong vibrations from the machine.
Such vibrations indicate that the
attachment's shaft is bent. Never use an
attachment with a bent shaft; replace it.
•
Caution: Do not use grinding or cutting
discs with a diameter larger than 25 mm.
Such discs can shatter and cause serious
injury due to the machine's high operating
speed.