Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
➀
2 3
4
ANTENNA-B
➁
7
2-Channel
Multifrequency Receiver
These instructions are intended for users
without any specific technical knowledge .
Please read these instructions carefully prior to
operating the unit and keep them for later
reference .
1 Overview
Receiver 1
Receiver 2
1
Receiving antennas
2
IR transmitting diode
3
Button ADL, to transfer the radio frequency
of the receiver to the transmitter by IR sig-
nal; settings for the transmitter (transmis-
sion power and gain) made on the receiver
will also be transferred
4
Display (
☞
chapter 1 .1)
1.1 Display
Indication
Function
strength of the radio signal received
volume of the audio signal received
radio frequency
group
an antenna symbol will indicate the receiver
section (A or B) receiving the radio signal of
the highest quality
5
2 3
2 IN 1 MIX
2 IN 1 MIX
CHANNEL 2
UNBALANCED OUTPUT
BALANCED OUTPUT
BALANCED OUTPUT
8
5
Buttons SET, AUTO,
Automatic lock function:
A short while after switching on and after
the last operation, the buttons SET, AUTO,
and
will be locked automatically
(lock symbol
on the display) . To unlock
the buttons, keep the button SET pressed
for approx . 1 second .
1. Setting mode:
When the buttons are un locked, use
the button SET to call up the following
functions one after another:
Group setting channel setting squelch
setting setting of transmission power for the
transmitter gain setting for the transmitter
exit of setting mode
As long as the indication of the function
selected keeps flashing, settings can be
made with the buttons
2. Volume:
When the buttons are unlocked, use the
buttons
and
to set the volume for
the output signal of the receiver (range
0 ... 63) .
channel
4
5
12-18 V
CHANNEL 1
BALANCED OUTPUT
9
10
and
3. Automatic channel scan:
When the buttons are unlocked, press
the button AUTO to start the channel
scan within a group .
6
Button POWER to switch the receiver on / off
(keep button pressed for approx . 1 second)
7
Antenna inputs A and B (BNC jacks)
8
Audio outputs 2 IN 1 MIX for the mixed sig-
nal of receiver 1 and receiver 2:
– XLR chassis plug, balanced
– 6 .3 mm jack, unbalanced
9
Audio outputs (XLR chassis plugs, bal-
anced), one each for receiver 1 (CHAN-
NEL 1) and receiver 2 (CHANNEL 2)
10 Power supply jack to connect the power
supply unit provided
and
.
Indication
Function
wave symbol will pulsate during IR transmission
starts flashing during the channel scan
squelch, adjustable in 3 levels
buttons SET, AUTO,
setting for the transmitter:
transmission power, adjustable in 3 levels
setting for the transmitter:
matching of volume level (0 dB, –3 dB, –6 dB)
indicates the battery status of the transmitter in several
levels
1
6
ANTENNA-A
7
,
locked
7
Publicidad
Tabla de contenido
