Gaggia Milano VIVA STYLE-CHIC RI8433 Instrucciones De Uso página 15

English
14
10 Turn the filter holder from left to right until it locks in place. Release the handle, that will turn
slightly leftwards (fig.11). Once released, the handle shall be perpendicular to the machine or slightly
shifted rightwards (fig. 29).
11 Place one or two cups under the pressurised filter holder (fig. 17).
Ensure that the cups are correctly positioned under the coffee brewing spouts.
12 Turn the selection knob up to the coffee position.
- The machine will start dispensing the coffee.
13 Turn the selection handle to the standby position once the cup or cups have the desired amount
of coffee.
14 Remove the pressurized filter holder and empty it. Clean the pressurized filter holder under
running water.
Note: The machine switches off after 30 minutes and switches to energy saving mode. Should this
occur, use the on/off button located at the rear of the machine to restart the machine.
Brewing coffee using coffee pods
Tip: Clean the filter and coffee pod adapter after each use.
1 Use a teaspoon to remove pre-ground coffee from the pressurised filter holder (fig. 18).
2 Take the pod adapter and filter positioned beneath the water tank lid.
3 Use a teaspoon to remove the adapter from the pod filter. (fig. 28).
4 Insert the pod filter adapter into the pressurised filter holder with the convex side facing
downwards (fig. 19).
5 Place the coffee pod filter on the adapter into the filter holder (fig. 20).
6 Insert the filter holder into the coffee brew unit from the bottom (fig. 10).
7 Turn the filter holder from left to right until it locks in place. Release the handle, that will turn
slightly leftwards (fig.11). Once released, the handle shall be perpendicular to the machine or slightly
shifted rightwards (fig. 29).
Note: The pressurized filter holder must be pre-heated when brewing coffee for the first time.
8 Turn the selection knob to the coffee position (fig. 7) to dispense one cup of water. Turn the
selection knob back to the standby position (fig. 8) to stop dispensing.
9 Turn the filter holder from right to left to remove it from the machine and pour the residual water
(fig. 14) but do not dry it.
10 Insert one single-dose coffee pod into the filter holder (fig. 21).
Note: ensure that the pod foil does not project from the edge of the filter holder.
11 Insert the filter holder into the coffee brew unit from the bottom (fig. 10).
12 Turn the filter holder from left to right until it locks in place. Release the handle, that will turn
slightly leftwards (fig.11). Once released, the handle shall be perpendicular to the machine or slightly
shifted rightwards (fig. 29).
13 Place a cup under the filter holder.
14 Turn the selection knob up to the coffee position (fig. 7).
-
The machine will start dispensing the coffee.
15 Turn the selection handle to the standby position once the cup has the desired amount of coffee.
16 Remove the filter holder and dispose the used coffee pod.