Descargar Imprimir esta página

Genesis GMS15LB Manual Del Operario página 14

Sierra ingleteadora combinada de 254mm (10 pulg.) guiada con láser

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Bevel set at 33.85°
4. Make cut, save right end of cut
right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62°
3. Bevel set at 33.85°
4. Save right end of cut
CUTTING WARPED WORKPIECES
note: it is recommended that you do not cut warped material.
Sometimes you have no choice but to use a piece of warped material. To cut warped work pieces, make sure it is positioned on the miter saw table with
the convex side against the fence. DO NOT place the concave side of the work piece against the miter saw fence; when it is cut it will collapse near the
completion of the cut, pinching the blade.
WArning:
To avoid possible serious personal injury and possible kickback, never place the concave portion of bowed or warped
material against the fence.
MAinTEnAnCE
SAW BLADE INSTALLATION OR REMOVAL
WArning:
Be sure that the tool is switched off and unplugged from the power source before performing any
work on the tool.
WArning:
Use only 10" diameter saw blades that have 5/8" diameter arbor holes and are rated for speeds
equal to or greater then the nameplate rated rPM of this miter saw.
WArning:
Use only blades designed for cross-cutting operations.
WArning:
Do not use thin kerf blades with deep gullets which may deflect and contact the blade guards or
produce poor quality cuts in the work piece.
To remove the blade
1. unplug the tool from the power source.
2. unlock and move the saw arm fully upright.
3. Rotate the lower guard upwards to Blade Changing Position (See FIG 13). Blade locking bolt is exposed through the blade changing hole on the
lower guard.
4. Keep the lower guard in position with the palm of your right hand. Depress the rectangular spindle lock button below the carrying handle with
your index or middle finger, and rotate the blade until it is locked in place by the spindle lock.
(See FIG 14)
5. Maintain pressure on the spindle lock and keep the lower guard in the blade changing post ion with your right hand. using your left hand and the
supplied Allen wrench, rotate the blade locking bolt clockwise to loosen. (See FIG 15).
6. Remove the blade locking bolt, small washer and outer blade flange washer.
7. Rotate the lower guard upwards as far as possible, then remove the blade from the motor spindle..
FIG 13
Blade Changing Position
10" Compound Laser Miter Saw
Operator's Manual
FIG 14
GMS15LB
FIG 15

Publicidad

loading