Descargar Imprimir esta página

ZIGOR ZGR QUICK 600 Guía Rápida página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

ZGR QUICK
This unit is shipped from the factory with its internal battery fully charged, however, some charge may be lost during
shipping and the battery should be recharged prior to use. Turn on the UPS, plug the unit into an appropriate power
supply and allow the UPS to charge fully by leaving it plugged in for at least 6 hours with no load connected. (no
electrical devices such as computers, monitors, etc.)
Placement
6.
Install the UPS unit in any protected environment that provides adequate airflow around the unit, and is free from
excessive dust, corrosive fumes and conductive contaminants. Do not operate your UPS in an environment where
the ambient temperature or humidity is high.
On the other hand, place the UPS away from the monitor at least 20 cm to avoid interference.
Connection
7.
Plug the UPS into a 2-pole, 3-wire grounded receptacle. Then connect each computer-related device into the output
sockets supplied on the top of the UPS. Do not connect Laser printer to Essential outlets (OUTPUT), because they
are high peak current devices and this UPS may not support and could be damaged permanently.
Turn On/Off
8.
To turn on the UPS unit, press the power switch lightly.
To turn off the UPS unit, press the power switch again.
DC Start
9.
All of our UPS devices are equipped with DC Start.
To start the UPS when AC utility power is not available, simply press the power switch.
10. Important safety warning (SAVE THESE INSTRUCTIONS)
 This UPS utilizes voltages that may be hazardous. Do not attempt to disassemble the unit. The unit contains no
user serviceable parts. Only factory service personnel may perform repairs.
 Internal battery voltage is 12 Vdc. Sealed lead-acid, 6 cells battery.
 Connection to any other type of receptacle other than a two-pole, three-wire grounded receptacle may result in
shock hazard as well as violate local electrical codes.
 In the event of an emergency, press the OFF button and disconnect the power cord from the AC power supply to
properly disable the UPS.
 Do not allow liquids or any foreign object to enter the UPS. Do not place beverages or any other liquid-containing
30987500
QUICK GUIDE
www.zigor.com
8

Publicidad

loading

Este manual también es adecuado para:

Zgr quick 800