Publicidad
Idiomas disponibles
Idiomas disponibles
Touch the ON/OFF control for three seconds. After power on, the
buzzer beeps once, all displays show "-" or "—", indicating that
the induction hob has entered the state of standby mode.
Place a suitable pan on the cooking zone that you wish to use.
•
Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry.
Touching the heating zone slider control, and a indicator next to
the key will flash.
Select a heat setting by touching the slider control.
•
If you don't choose a heat setting within 1 minute, the
Induction hob will automatically switch off. You will need
to start again at step 1.
•
You can modify the heat setting at any time during
cooking.
If the display flashes
This means that:
•
you have not placed a pan on the correct cooking zone or,
•
the pan you're using is not suitable for induction cooking or,
•
the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minute if no suitable pan is placed on it.
3.3.2
Finish cooking
Touching the heating zone selection control that you
wish to switch off.
Turn the cooking zone off by touching the slider to "
1 Make sure the display shows "0".
alternately with the heat setting
11
power up
power down
Publicidad
