Publicidad
Idiomas disponibles
Idiomas disponibles
stop. Then, back the saw out of the cut. Restart the saw and re-enter
the cut, following the desired cutting line.
WARNING: Do not stack materials for cutting. Do not cut through
bolts with the saw. Do not touch the blade, workpiece or metal chips
with your bare hand immediately after cutting—they are extremely
hot and may burn your skin.
Maximizing Blade Life
To extend blade life, follow these practices:
• Do not force the blade through the metal. The saw must cut at its
own pace and at a constant rate.
• Change blades when it is no longer easy to push the saw through
the cut, when the motor is straining, or when excessive heat is built
up in the blade.
• Keep base of the saw firmly against metal you are cutting.
• If the metal you are cutting is vibrating or shaking, clamp the
material as close to the cut as possible and slow down the cutting
rate.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
Replacing Sight Window (Fig. 2)
WARNING: Do not operate the saw with a damaged or missing
sight window. If window is damaged or missing, have the saw
serviced at an authorized service center. If the saw is operated
without the window, metal chips could fly through the guard and
cause personal injury.
The sight window (J) must be replaced by an authorized D
service center.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CAUTION: Do not use any cleaning fluids on the sight window to
avoid clouding it and compromising the safe operation of the saw.
Use compressed air to remove accumulated dust from the inside of
the sight window. Wear safety glasses when performing this.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do
not use water or any cleaning solutions.
Lubrication
Self lubricating ball and roller bearings are used in the tool and
relubrication is not required. However, it is recommended that, once
a year, you take or send the tool to a certified service center for a
thorough cleaning, inspection, and lubrication of the gear case.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
WALT recommended accessories should be used with
e
this product.
WALT
e
Use only 5-1/2" (140 mm) D
arbor.
18
WALT metal-cutting blades with a 20 mm
e
Publicidad
