Setting Mode; Meanings Of Items Shown In Setting Mode; Clock Mode Setting; Output Connector Setting - Esoteric N-03T Manual Del Usuario

Setting mode

1
Press the MENU button repeatedly to select the
item to change.
Each time you press the MENU button, the item shown on the
display changes as follows.
CLK>
c
DOUT>
c
DSD>
c
DISP>
o If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume.
2
Use the setting adjustment (+/−) buttons to
change the settings.
For information about the settings, see pages 12–13.
o If you do nothing for ten or more seconds, setting mode will
end and ordinary display will resume.
o Settings are retained even if the power plug is disconnected.
12
Setting complete
(display returns to
usual state)
3
DIMMER>
3
APS>
3
DPaOFF>

Meanings of items shown in setting mode

CLK>***

Clock mode setting

DOUT>***

Output connector setting

DSD>***
DSD output setting
DISP>***
Network display setting
DPaOFF>***
Automatic display darkening setting
APS>***
Automatic power saving setting
DIMMER>***
Dimmer setting
Clock mode setting
CLK>***
o This is only activated when the output connector setting is XLR or
RCA.
o When the output connector setting is USB, the connected D/A
converter controls the clock, so there is no need to supply an
external clock signal to this unit.
o By default, the setting is OFF.
OFF
The built-in crystal oscillator operates as the master clock.
IN
The built-in crystal oscillator is synchronized to an external clock.
Output connector setting
DOUT>***
o By default, the setting is USB.
USB
The digital signal is output from the USB port.
XLR
The digital signal is output from the XLR connector.
RCA
The digital signal is output from the RCA connector.