Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
• Unit will not start.
For assistance with your product, visit our website at www.stanleytools.com. for a list of
service centers, or call the Stanley FatMax Customer Care Center at (800) 262-2161
MAINTENANCE
WARNING:
uNPluG SAW AND REMoVE ACCESSoRY WhEN PERFoRMING
ANY ClEANING oR oThER MAINTENANCE. WhEN SERVICING uSE oNlY
IDENTICAl REPlACEMENT PARTS.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside
the tool; never immerse any part of the tool into a liquid.
• Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
various types of commercial solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust etc.
• When electric tools are used on fiberglass boats, sports cars, drywall etc., they are
subject to accelerated wear and possible premature failure, as the fiberglass
chips and grindings and drywall dust are highly abrasive to bearings, brushes,
commutator, etc. During any use on fiberglass or drywall it is extremely important
that the tool be cleaned frequently by blowing with an air jet.
luBRICATIoN
Stanley FatMax tools are properly lubricated at the factory and are ready for use.
Tools should be lubricated regularly every year depending on usage. (Tools used on
heavy duty jobs and tools exposed to heat may require more frequent lubrication.) This
lubrication should be attempted only by trained power tool repair person such as those
at Stanley FatMax service centers or in other qualified service personnel.
REPlACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.stanleytools.com. You can also order parts from your nearest Stanley FatMax
Factory Service Center or Stanley FatMax Authorized Warranty Service Center. Or, you can
call our Customer Care Center at (800) 262 2161.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about Stanley FatMax, its factory service centers or authorized warranty
service centers, visit our website at www.stanleytools.com or call our Customer Care
Center at (800) 262 2161. All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at Stanley Tools, 701 E. Joppa Road, Towson,
Maryland 21286 - Attention: Product Service. Be sure to include all of the information
shown on the nameplate of your tool (model number, type, serial number, etc.).
TRouBlEShooTING
Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Stanley FatMax
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a
Stanley FatMax service center
or authorized servicer.)
• Have cord or switch replaced
at a Stanley FatMax Service
Center or Authorized Servicer
8
Publicidad
