Flex DD 4G 18.0-EC Instrucciones De Funcionamiento Originales página 22

 Insert the tool.
 Close the chuck fully.
NOTE
Carry out a test run to check that the tool is
chucked in the centre.
Angle attachment WV 18.0-EC
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (4)
to the middle position.
The angle attachment facilitates working in
places which are difficult to access.
The angle attachment can be locked in
different 30° angular positions.
Assemble
 Pull unlocking ring forwards (1.) and
press angle attachment all the way onto
the tool holder (2.).
 Lock angle attachment in the required
angular position.
 Release unlocking ring. Check that the
attachment is locked in position.
Disassemble
 Pull unlocking ring forwards and remove
angle attachment.
22
Inserting the tools
The angle attachment has a
Screwdriver bits and bit holders are
securely held in the tool holder.
The keyless chuck (see "Changeable drill
chuck BF 18.0-EC") or the bit holder (see
"Bit holder attachment BV 18.0-EC") can be
mounted on the angle attachment.
Bit holder attachment BV 18.0-EC
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (4)
to the middle position.
Assemble
 Pull unlocking ring forwards (1.) and
press bit holder attachment all the way
onto the tool holder (2.).
 Release unlocking ring. Check that the bit
holder attachment is locked in position.
DD 4G 18.0-EC
½
" tool holder.