Publicidad
Idiomas disponibles
Idiomas disponibles
DD 4G 18.0-EC
Disassemble
Pull unlocking ring forwards and remove
bit holder attachment.
Inserting the tools
The bit holder attachment has a
holder. Screw-driver bits are securely held
in the tool holder.
Pull tool lock forwards (1.) and press in
the tool all the way (2.).
Release tool lock.
To remove the tool, pull tool lock
backwards.
Inserting/replacing the battery
Press the charged battery into the power
tool until it clicks into place.
To remove, press the release button (1.)
and pull out the battery (2.).
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
½
" tool
Battery state of charge
Press the button to check the state of
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Direction preselection
Change the direction of rotation only when
the power tool is stopped.
Move the direction preselector switch to
CAUTION!
charge at the state of charge indicator
LEDs.
CAUTION!
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock (tool change,
when working on the power tool)
23
Publicidad
