Stanley SB01AL Manual De Instruccion página 4

• Only use the flexible stand and magnetic discs for attaching the work light. The flexible stand and
magnetic discs are not intended to support additional weight. Do not attach anything additional
to the light or risk of breakage may occur.
Using the Optional Camera Attachment Bar
The flexible rubber groove stand can also be used as a camera tripod. Refer to the following
illustration.
CAMERA
TO ATTACH THE CAMERA:
1. Slide the SquidBrite™ attachment bar out of the light holder groove.
2. Screw the camera attachment bar's screw post into the camera's tripod socket (clockwise).
3. Slide the camera attachment bar into the light holder groove.
TO DETACH THE CAMERA:
1. Slide the camera attachment bar out of the light holder groove.
2. Unscrew the camera attachment bar's screw post from the camera's tripod socket
(counterclockwise).
CARE AND MAINTENANCE
Never submerge the unit in liquids of any kind. If the unit gets dirty, gently clean the outer surfaces
of the closed body casing with a soft cloth moistened with a mild solution of water and detergent.
Except for the batteries, there are no user-serviceable parts inside. Contact the manufacturer if any
components have become worn or broken.
SB01AL_SBALCSB_SBALCSR_SBALCSY_Manual_ENSP_051614.indd 6-7
CAMERA
ATTACHMENT BAR
FLEXIBLE RUBBER
GROOVE STAND
6
Safe Battery Disposal
Refer to the Safety Warnings in the front of this Instruction Manual when selecting and replacing
batteries. Always dispose of used batteries properly.
WARNING: TO REDUCE THE RISK OF INJURY/EXPLOSION:
• Do not dispose of batteries in fire as this may result in an explosion.
• Do not expose the unit containing batteries to fire or intense heat as it may explode.
TROUBLESHOOTING
Light will not operate
1. The back cover screw may be loose. Screw the back cover screw clockwise to secure. Do not over-
tighten.
2. The batteries may be completely discharged. Replace the batteries following the directions given
in this manual.
3. If the light does not operate after replacing the batteries and tightening the back cover, contact
manufacturer at (877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool may be available from the manufacturer. If you
need assistance regarding accessories, please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be
hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the
manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period
of ONE (1) YEAR from the date of retail purchase by the original end-user purchaser ("Warranty
Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product
can be replaced or repaired in the following ways: (1) Return the product to the manufacturer
for repair or replacement at manufacturer's option. Proof of purchase may be required by
manufacturer. (2) Return the product to the retailer where product was purchased for an exchange
(provided that the store is a participating retailer). Returns to retailer should be made within the
time period of the retailer's return policy for exchanges only (usually 30 to 90 days after the sale).
Proof of purchase may be required. Please check with the retailer for their specific return policy
regarding returns that are beyond the time set for exchanges.
7
5/16/2014 11:18:16 AM