Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 27 Friday, December 2, 2022 4:16 PM
Problem
Rinse+Spin LED
Special drain feature
Blinks
• If the washer is paused during a cycle for more than 4 minutes, the cycle will be canceled
DRAIN FEATURE
• This is not an error code. It indicates that the drain function is operating.
Door Lock and
Lid is not closed properly.
Control Lock LEDs
• Close the lid properly.
Blink
• If the lid is closed and this error message is still displayed, call for service.
LID ERROR
Door Lock LED Blinks
Lid is not locked properly.
LID LOCK ERROR
• Make sure that the lid is closed properly and press the Start/Pause button. You can hear
• Make sure that nothing is caught under the lid, including shipping material or clothing.
• Make sure that the latch mechanism is fully retracted.Make sure that the latch mechanism
• If the lid is closed and this error message is still displayed, call for service.
Extra Rinse and Cold
Foreign objects such as coins, pins, clips, etc., are caught between the pulsator and the
LEDs Blink
inner tub.
FOREIGN OBJECT
• Turn the washer off then on again. Press the Spin button without selecting a cycle to drain
ERROR
• When the Spin cycle is completed, empty the tub and find and remove any objects caught
• Always check pockets, etc., before washing to prevent error codes or damage to the
Tub Clean LED Blinks
It is time to run the Tub Clean cycle.
TUB CLEAN ALARM
• This is not an error code. It indicates that the Tub Clean cycle is running or needs to be run
• Not applicable for all models.
Rinse+Spin and
Control error
Warm LEDs Blink
• Unplug the washer and wait 60 minutes. Reconnect power and try again.
TEMPERATURE
• If the error code is still displayed, call for service.
SENSOR ERROR
Rinse+Spin and Cold
Water level is too high due to a faulty water valve.
LEDs Blink
• Close the water faucets, unplug the washer, and call for service.
OVERFLOW ERROR
Hot LED Blinks
The water level sensor is not working correctly.
PRESSURE SENSOR
• Close the water faucets, unplug the washer, and call for service.
ERROR
Deep Fill and Cold
A motor error has occurred.
LEDs Blink
• Allow the washer to stand for 30 minutes and then restart the cycle.
MOTOR LOCKED
• If the error code is still displayed, call for service.
ERROR
Deep Fill LED Blinks
Clutch error
CLUTCH ERROR
• Mechanical failure
• Unplug the washer and call for service.
Deep Fill and Warm
Supply voltage is not correct.
LEDs Blink
• Please call LG service center. You can find your local LG service center phone number
SUPPLY VOLTAGE
ERROR
and any water remaining in the tub will be drained.
the locking sound to lock the lid in the beginning of the cycle. The washer will not operate
unless the lid is locked.
is fully retracted.
and spin the load.
in the pulsator.
washer or clothing.
to clean the washer tub.
onback cover page.
TROUBLESHOOTING
Possible Cause & Solution
27
Publicidad
