Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Use of this tool can generate and/or disperse
dust, which may cause serious and permanent respiratory or
other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away
from face and body.
CAUTION: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this product
may contribute to hearing loss.
CAUTION: Do not connect unit to electrical power source
until complete instructions are read and understood.
For your convenience and safety, the following warning labels
are on your miter saw.
ON MOTOR HOUSING:
WARNING: FOR YOUR OWN SAFETY, READ INSTRUCTION
MANUAL BEFORE OPERATING SAW. WHEN SERVICING, USE
ONLY IDENTICAL REPLACEMENT PARTS. ALWAYS WEAR EYE
PROTECTION.
ON MOVING FENCE:
ALWAYS ADJUST FENCE
PROPERLY BEFORE USE.
CLAMP SMALL PIECES BEFORE CUTTING. SEE MANUAL.
ON GUARD: DANGER – KEEP AWAY FROM BLADE.
ON GUARD RETAINER PLATE: "PROPERLY SECURE
BRACKET WITH BOTH SCREWS BEFORE USE."
If you have any questions, call 1-800-54-HOW-TO
ON TABLE: (2 PLACES)
ALWAYS TIGHTEN ADJUSTMENT KNOBS BEFORE USE. KEEP
HANDS 6" FROM PATH OF SAW BLADE. NEVER PERFORM ANY
OPERATION FREEHAND. NEVER CROSS ARMS IN FRONT OF
BLADE. THINK! YOU CAN PREVENT ACCIDENTS. DO NOT
OPERATE SAW WITHOUT GUARDS IN PLACE. NEVER REACH
IN BACK OF SAW BLADE. ALWAYS WEAR EYE PROTECTION.
SHUT OFF POWER AND WAIT FOR BLADE TO STOP BEFORE
SERVICING, ADJUSTING TOOL, OR MOVING HANDS.
Electrical Connection
Be sure your power supply agrees with the nameplate marking. 120
volts, AC/DC means that your saw will operate on alternating or
direct current. A voltage decrease of 10 percent or more will cause a
loss of power and overheating. All Black & Decker tools are factory
tested. If this tool does not operate, check the power supply.
Unpacking Your Saw
Check the contents of your miter saw carton to make sure that you
have received all parts. In addition to this instruction manual, the
ALWAYS ADJUST FENCE PROPERLY
FS1500CMS miter saw with blade and a plastic bag containing the
BEFORE USE. CLAMP SMALL PIECES
following: 1. Miter clamp handle (1)
BEFORE CUTTING. SEE MANUAL.
DANGER
KEEP AWAY
FROM BLADE
Familiarization
Place the saw on a smooth, flat surface such as a workbench or
strong table.
Examine Figures 1 & 2 and refer to the parts description to become
familiar with the saw and its various parts. The following section on
adjustments will refer to these terms and you must know what and
where the parts are. The part name is followed by the corresponding
10
2. Dust bag (1)
3. Work extensions (2) with clamps (2) and screws (2)
4. Stop block (1) with wing screw (1)
5. Allen wrenches (3)
Publicidad
