Publicidad
Idiomas disponibles
Idiomas disponibles
part number Example - lock down pin (14).
Press down lightly on the operating handle and pull out the lock down
pin (14), as shown in Figure 3. Gently release the downward
pressure and allow the arm to rise to its full height. Use the lock down
pin when carrying the saw from one place to another. Use the
operating handle (1) to transport the saw or the hand indentations
(15) shown in Figure 2 after unplugging.
Specifications
CAPACITY OF CUT
47 degree miter left and right
47 degree bevel left: 2 degree right
0 degree miter - Max. Height 3-1/2 inches - Max. Width 5-1/2 inches
45 degree miter - Max. Height 3-1/2 inches - Max. Width 4-1/8 inches
45 degree bevel - Max. Height 2-1/2 inches - Max. Width 5-1/2 inches
Bench Mounting
Bench mounting holes (8) are provided in all four feet to facilitate
bench mounting, as shown in Figure 1. (Two different sized holes are
provided to accommodate different sizes of screws. Use either hole, it
is not necessary to use both.) Always mount your saw firmly to
prevent movement. To enhance the tool's portability, it can be
mounted to a piece of 1/2" or thicker plywood which can then be
clamped to your work support or moved to other job sites
and reclamped. NOTE: If you elect to mount your saw to a piece of
plywood, make sure that the mounting screws don't protrude from the
bottom of the wood. The plywood must sit flush on the work support.
When clamping the saw to any work surface, clamp only on the
clamping bosses where the mounting screw holes are located.
Clamping at any other point will interfere with the proper operation of
the saw.
CAUTION: To prevent binding and inaccuracy, be sure the
mounting surface is not warped or otherwise uneven. If the saw rocks
on the surface, place a thin piece of material under one saw foot until
the saw sits firmly on the mounting surface.
Important Safety Instructions
Changing or Installing a New Saw Blade
CAUTION:
•Never depress the spindle lock button while the blade is under
power or coasting.
•Do not cut ferrous metal (containing iron or steel) or masonry or fiber
cement product with this miter saw.
Removing the Blade
1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower guard (2)
as far as possible.
3. Loosen, but do not remove guard bracket screw (figure 4) until the
bracket can be raised far enough to access the blade screw. Lower
guard will remain raised due to the position of the guard bracket
screw.
4. Depress the spindle lock button (19) while carefully rotating the
saw blade by hand until the lock engages.
5. Keeping the button depressed, use the other hand and the wrench
provided to loosen the blade screw as shown in figure 5. (Turn
clockwise, left-hand threads)
6. Remove the blade screw, outer clamp washer, and blade.
Installing a Blade
1. Unplug the saw.
2. With the arm raised, the lower guard held open and the pivot plate
raised, place the blade on the spindle, and against the inner clamp
washer with the teeth at the bottom of the blade pointing toward the
back of the saw.
3. Assemble the outer clamp washer onto the spindle.
4. Install the blade screw and, engaging the spindle lock, tighten the
screw firmly with wrench provided. (Turn counterclockwise,
left-hand threads)
11
If you have any questions, call 1-800-54-HOW-TO
Publicidad
