FAR 70AX83 Traduccion De Las Instrucciones página 12

HOW TO USE YOUR RIVETING TOOL
After the clamping, the sheared nail is piped by the riveting tool and ejected from the back into the special container (B).
By swinging the valve (A) you can adjust the suction power. By the suction nail system, the rivet remains in the nozzle also
turning over the head of the riveting tool downwards: this detail increases a lot the usefulness of the riveting tool. Do not keep
the rivet with your fingers!
WARNING!! Do not remove the container (B) during the riveting operation, as the nail ejection can
cause damages to the worker or to persons who are nearby the work surface.
f1
When the container (B) is full of nails do not use the riveting tool. Disconnect the tool, unscrew the container (B) and empty it.
DO NOT DISPERSE ANY NAIL! Screw the container and start again to work.
12
A
750301 - RAC 83 AX – rev 11 - ( 09-2022 )
GB
f2
RAC 83 AX
B