BE QUIET! SFX POWER 3 Manual Del Usuario página 5

1. INTRODUCTION
We are delighted that you have chosen to use a be quiet! power supply from
our SFX Power 3 / TFX Power 3 series in your PC� Please read and follow all the
information contained in these instructions carefully prior to installation� Should
you have any further questions, please contact our customer service� See contact
information in item Manufacturer's details�
2. SAFETY INSTRUCTIONS
The power supply is only guaranteed to function properly if the
instructions are followed�
Caution: Only use the supplied cable set� Using cables that were not included (e�g�
cables of older power supply unit series) may lead to defects!
Never open the power supply case� The electronic components inside the case
generate a high voltage that is dangerous to humans� Even after disconnecting
the power supply from the network, some parts still have high voltages� For this
reason, a power supply adapter should only be opened by an authorised technician�
Opening the device voids your warranty.
∙ Never handle the power supply with wet or damp hands when in operation�
∙ Never insert objects into the power supply's apertures/fans�
∙ Note that the power supply is designed for use indoors in conditions without
high levels of moisture in the ambient air� Using the power supply outdoors will
lead to serious damage�
∙ Never work on the power supply while it is connected to the mains� In this case,
always set the power switch to "0" and / or disconnect the power plug�
∙ In the event of a short circuit in the device, unplug the mains cable and do not
use the device�
Make sure that your PC is not located directly next to a heating system or any other
source of heat�
Make sure that your computer case is sufficiently ventilated by means of additional
fans; with today's complex and powerful systems a power supply is incapable of
dissipating the heat produced in the PC case without additional support�
If you want to clean your power supply, disconnect it completely from the mains
and never use a damp cloth or cleaning agent� Clean the power supply from the
outside using a dry cloth�
5