Publicidad
Idiomas disponibles
Idiomas disponibles
1. Prepare the Site
If applicable, remove the existing toilet seat.
Turn OFF the water supply to the toilet.
Flush the toilet to relieve any pressure from the supply hose.
Disconnect the water supply hose from the toilet fill valve.
Install an Electrical Outlet
WARNING: Risk of electric shock. Connect only to a properly-grounded
dedicated circuit protected by a Class A Ground-Fault Circuit-Interrupter
(GFCI)*. Use 120 V, 60 Hz, 15 A service. Do not remove the grounding pin or
use a grounding adapter.
*Outside North America, this may be known as a Residual Current Device (RCD).
NOTE: Follow local codes when determining the electrical outlet location.
Install a dedicated 120 V GFCI-protected electrical outlet within 32" (813 mm) of
the toilet to accommodate the length of the power cord.
Do not plug the seat into the electrical outlet at this time.
Kohler Co.
5
1321456-2-C
Publicidad
