Grundig CDP 180 Manual Del Usuario página 21

Programming
By programming the player you can play up to 20 tracks in
any desired order. If you exceed the maximum of 20 tracks,
the programme function will start again from the beginning.
You may store each track more than once.
Storing a programme
• Insert a CD and close the compartment.
• Press the PLAY·PAUSE 2; button to read the CD.
• Press the PROG button
and the display will flash
the letters 'PGM'.
• Select the first desired track using SKIP·SEARCH S or T.
– The display shows e.g.:
• Store this number by pressing the
PROG button.
– The display shows:
• Select and store in this way all
desired titles.
PROGRAMMING
Playing the programme
• Press PLAY·PAUSE 2;.
– Playback starts with the first track of the programme.
– The display shows 'PGM'.
– After the last track playback stops.
The total playing time and number of
tracks appear on the display.
Note:
While playing a programme, it is possible to use
SKIP·SEARCH S or T to select the desired programmed
tracks.
Checking the programme
• Press the PROG button repeatedly until 'PGM' flashes on the
display.
– Each press of the PROG button will now show each stored
number in the order entered.
– Then, '00' appears again.
• You can now add tracks to the sequence as described
above (up to 20).
Erasing the programme
The contents of the memory will be erased:
– when you switch off the player;
– if the batteries become exhausted or if the power supply is
interrupted in another way.
– when the CD compartment is opened.
GB
21