Sage SJE530 Guía Rápida página 7

7. Slide the food pusher down the food chute
by aligning the groove in the food pusher,
with the small protrusion on the inside of the
top of the feed tube.
Food
pusher
groove
8. Place the pulp container into position by
tilting and lifting the motor base slightly.
Insert the pulp container under the juicer
cover on the back ensuring it is supported by
the juicer cover and motor base.
9. Fit the lid to the juice jug and position jug
under juice spout.
Juice jug
Juice can be preserved in the juice jug for up to
3 days by following these steps.
1. Lift the lid off the jug and rotate 180°
2. Press down firmly to replace the lid
3. Store juice in the fridge
NOTE
Storage time depends on the ingredients being
juiced and the freshness of the fruit prior to juicing.
Juice must be stored in the refrigerator between
2°C to 4°C.
1. Wash your selection of fruit and vegetables
to be juiced. Most fruit and vegetables
such as apples, carrots and cucumbers
will not need to be cut or trimmed to
size as these will fit whole into the feed
chute. Ensure vegetables such as beets,
carrots etc. have all soil removed, are
washed well and trimmed of leaves
Small
protrusion
before using.
inside
2. Plug the power cord into a 220V – 240V
feed tube
power outlet.
IMPORTANT
Do not load Feed Chute with produce before
the Juicer has reached the selected speed.
3. Turning the Juicer On
Turn dial to desired speed setting. Turn
Dial to "Low" setting for soft fruits and
vegetables and to "High" setting for hard
fruits and vegetables. See Speed Selector
Guide table on the next page to match
speed and produce type for maximum yield.
"Low" range, while it may not maximise
yield of some produce, allows you to
extract juice at a significantly lower noise.
4. With the motor running, place food into
the feed chute and use the food pusher
to gently guide food down. To extract the
maximum amount of juice, always push
the food pusher down slowly.
5. Full Juice Jug
You can keep juicing until the Juice Jug
is filled to max. level.
6. Continuous Juicing
Having just filled and removed a Juice
Jug with fresh juice, you can place an
empty Juice Jug back onto the nozzle and
continue juicing without disassembly. When
the Pulp Container is near full with pulp, turn
the Dial to "Off", remove the Pulp Container
only and empty contents. Replace the
empty Pulp Container and turn Dial to
desired speed selection to continue juicing.
Functions
EN
7