Descargar Imprimir esta página

Allen + Roth LWFP58-7 Instrucciones De Montaje página 7

Chimenea eléctrica de 147,32 cm

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
19a. Put the cam lock covers (KK) onto the visible cam locks to conseal
the cams.
19b. Stick the rubber bumpers (LL) on the outer corners of doors where
the partition panels (T and U) are contact with .
Hardware Used
KK
Cam Lock Cover
LL
Rubber Bumper
Installing the fireplace insert
IMPORTANT NOTE: Use hand screwdriver, not power driver to assemble
fireplace insert. See BILT for video instructions.
20a. See figure A: Fasten upper 2 screws (AA) through the upright
arm (C) into the heater (A) until tight.
20b. See figure B: Fasten lower 2 screws (AA) into the upright arm
(C) until tight.
20c. Fully tighten all 4 screws (AA) one final time.
20d. Repeat the same process with upright arm (B).
WARNING: Do not lift or transport the heater by using the upright arms.
Hardware Used
M4 x 10 mm Screw
AA
IMPORTANT: Carefully follow the 2 steps below for inserting each log.
21a. Install left log (F) into left hole of ember bed (E) by inserting
front edge of base of the log into front notches of ember bed
hole.
21b.Then tilt the log back to insert the rear edge of the log base
into rear notches of ember bed hole (press down log firmly to
lock into position).
21c. Repeat the above process for the right log (G).
19
x 12
x 4
LL
KK
20
Figure A
A
C
B
AA
C
x 8
A
AA
21
F
E
1 1
F
E
12
Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS
22a. Set the ember bed (E) onto the heater (A) as shown.
22b. Push ember bed forward against the front flange of heater.
22c. Position the USB cable as shown.
A1
23a. Fold the wall panel (H) as shown. Then position yourself at
back side of heater (A).
23b. Hold wall panel (H) at the angle shown below and insert
lower back edge into metal slots on back of heater (A).
23c. Tilt wall panel (H) forward until bottom corner inserts into
lower U-channels on both upright arms (B and C).
23d. Continue to tilt wall panel (H) forward until the top corner inserts
into upper U-channels on both upright arms (B and C).
Figure B
24. Fully plug the USB connector of the ember bed (E) into the back
port of heater (A).
F
E
2 2
G
22
A
USB cable
23
U-channel
B
C
H
A
24
A
E
13
Lowes.com/allenandroth
E
E
A
H
A

Publicidad

loading

Este manual también es adecuado para:

5228469