Publicidad
Idiomas disponibles
Idiomas disponibles
Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take
it to a service center prior to continuing use.
NOZZLE:
How to Clean
If lint or other debris becomes lodged in nozzle, it
can be removed for cleaning.
CAUTION
!
To reduce the risk of injury from moving parts
- Unplug before servicing.
1. To prevent possible leaking, remove Clean
Water Tank and Dirty Water Tank.
2. With handle in upright position, tilt carpet
washer back so that handle rests on the floor.
3. Rotate nozzle latch to unlock position (Fig. 43).
4. Pull up on nozzle slightly to unsnap nozzle from
foot of carpet washer.
5. Pull nozzle forward to remove from carpet
washer. Be sure the nozzle does not get caught
on retention tank latch (Fig. 44).
6. Rinse debris from nozzle.
7. Position nozzle on to foot, making sure to align
the tabs at the bottom of the nozzle with the
notches on the foot (Fig. 45).
8. Snap nozzle to foot.
9. Rotate nozzle latch to lock position.
BRUSHES:
How to Change and Clean
Your cleaner is equipped with removable brushes.
Follow these directions for changing brush
assemblies or for easy cleaning.
CAUTION
!
To reduce the risk of injury from moving parts
- Unplug cleaner before servicing.
How to Remove
1. To prevent possible leaking, remove Clean
Water Tank and Dirty Water Tank.
2. With handle in upright position, tilt cleaner back
until handle rests on the floor.
3. Grab brush assembly and pull firmly (Fig. 46).
4. The brushes can be cleaned under running water.
MAINTENANCE
43
!
45
The nozzle must be in the proper position in
order for the Dirty Water Tank to go on properly
and for the unit to have proper suction.
46
!
How to Replace
1. Align posts (A) on both ends of brush assembly
with slots (B) in cleaner housing (Fig. 46).
2. Make sure that the hexagonal post (C) also
aligns with the hexagonal hole (D). Turn
brushes slightly until post fits easily into hole.
3. Press brush assembly firmly to snap into place.
16
Actual model may vary from images shown.
44
IMPORTANT
C
D
B
A
Publicidad
