Hilti DX 5 Manual página 26

1.3 Product-dependent symbols
1.3.1 Symbols
The following symbols are also used:
Warning! Observe the instructions.
Wear a hard hat while working with the tool.
Wear protective glasses while working with the tool.
Wear ear protection while working with the tool.
1.3.2 Symbols on the product
The following symbols are used on the product:
Black lock on a red background on the tool casing: On the release button for removing the ex-
haust gas piston return unit.
White lock on a black background on the fastener guide or on the magazine: On the fastener
guide release button.
1.3.3 Information shown on the display
The following information may be shown on the display:
This symbol indicates the battery's state of charge. When the battery is empty, the maintenance
symbol is shown.
This symbol indicates when the tool requires cleaning. One segment stands for 500 fasteners
driven. There are five segments in total, which means that 2500 fasteners can be driven before
cleaning is required.
This symbol indicates when servicing is due. It appears after 5 years, when 30,000 fasteners have
been driven, or when the battery is empty. Our recommendation: Please contact Hilti Service.
1.4 Product information
products are designed for professional users and only trained, authorized personnel are permitted
to operate, service and maintain the products. This personnel must be specifically informed about the
possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Fastening tool
Generation
Serial no.
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
18 English
Printed: 30.05.2018 | Doc-Nr: PUB / 5433084 / 000 / 00
DX 5
DX 5 GR
DX 5 SM
01
2211871
*2211871*