SEVERIN 7089000 Instrucciones De Uso página 15

∙ Rinse the dust container with water (use a mild detergent added to the water if necessary). Dry the dust container
thoroughly before putting it back into the appliance.
∙ Put the dust container insert back into the dust container and lock it in by turning clockwise.
∙ Place the dust container filter into the dust container with the black side facing downwards and lock it clockwise.
∙ Put the dust container lid on and lock it clockwise (
Cleaning or replacing the filter
∙ Clean the filter regularly, particularly under the following conditions:
∙ If suction power is lower than it should be
∙ before storing the appliance for an extended period, or
∙ before sending to the service centre.
∙ With household use, the filters must be replaced after 6 months.
Dust container filter:
∙ Take the filter out of the dust container (see the section on "Cleaning the dust container"). Remove the black insert.
∙ First, tap out the white filter, and then use the unfolded brush of the 2-in-1 tool to brush it out. Then tap out any loosened
dust residues again.
∙ The black foam insert in the filter can be washed, but must not be put in the dishwasher or washing machine.
∙ Rinse this insert thoroughly under running water.
∙ After cleaning, leave it to dry at room temperature for about 24 hours. Only put it back when it is completely dry.
Motor pre-filter:
∙ Take out the dust container and then take the motor pre-filter out of the appliance.
∙ The filter can be washed, but must not be put in the dishwasher or washing machine.
∙ Rinse the filter thoroughly under running water.
∙ After cleaning, leave it to dry at room temperature for about 24 hours. Only put it back when it is completely dry.
HEPA filter:
∙ Open the HEPA filter cover and take the filter out.
∙ First, tap out the filter, and then use the unfolded brush of the 2-in-1 tool to brush it out. Then tap out any loosened dust
residues again.
∙ Put the filter back in and close the cover.
Cleaning
∙ The housing and power cable may not be handled with liquids or immersed in liquids for reasons of electrical safety. Rub
housing with a slightly damp cloth and then dry.
∙ For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Storing the appliance
∙ For easy storage, when not in use, the floor nozzle can be hooked into the parking hook below the power control.
∙ So that as few problems as possible arise, it is important to empty the dust container regularly and6 take this opportunity
to check the filters and clean them if they are dirty.
∙ Before contacting our customer service, check with the help of below table whether you can correct the problem yourself.
/ → / ).
Troubleshooting by yourself
15