ims PRO TIG PRO 161 DC Manual página 23

• TIG DC - Advanced menu
It is possible to set the Start and Stop stages of the welding cycle.
%T_PULSE
START
The knob enables access to these settings :
Parameter Description
I_Start (ISA) Ignition phase current
T_Start (tSA) Iginition phase duration
I_Stop (ISo) Stop phase current
T_Stop (tSo) Stop phase duration
Time balance of the hot current (I) of the pulsation
%T_Pulse (dcY)
(access only by TIG DC Pulse)
The setting to modify can be selected by pressing the
the button. The advanced settings menu can be exited with «ESC».
CHOICE OF THE IGNITION TYPE
TIG HF: non-contact high-frequency ignition
TIG LIFT : Arcing by contact (for environments where HF is not desirable).
1 2
1 2
Warning: Increasing the length of the torch or earth return cables beyond the maximum length specified by the manufacturer will increase the risk
of electric shock.
TIG PRO 161 DC
F
(Hz)
TIG - HF 2T
TIG - Lift 4T
MMA 4T
LOG
TIG SPOT
The grey areas are not useful for this mode.
These advanced settings can be accessed by pressing the
SET and UP are displayed.
Once the button is released, use the knob to select «SET» from the dropdown menu
and confirm by pressing the
STOP
button. Once the modification is set with the main knob (I), it can be confirmed by pressing
3
1- Place the torch in the welding position above the part (distance of about 2-3 mm
between the electrode tip and the part).
2- Press the torch trigger (the arc starts without contact using High Frequency
impulsions).
3- The initial welding current circulates, the welding carries on according to the
welding cycle.
3
1- Position the torch nozzle and electrode tip on the part and press the torch button.
2- Tilt the torch until a distance of about 2-3 mm separates the tip of the electrode
from the part. The arc starts.
3- Put the position back into position to start the welding cycle.
A
V
JOB
s Hz
%
SETUP Press 3"
%
Pulse
Spot
MMA Pulse
button.
10% - 200% (12% by default)
10% - 100% (12% by default)
during 3 seconds until
Setting
0s - 10sec (0sec by default)
0s - 10sec (0sec by default)
20% - 80% (50% by default)
EN
23