Installing The Projector; Connecting; Connecting With A Computer - Sony VPL-PX1 Manual De Instrucciones

Installing the Projector / Connecting

Installing the Projector

This section describes the installation arrangements
for installing the projector.
Horizontal center
of the screen
The distance between the lens and the screen varies
depending on the size of the screen. Use the following table
as a guide.
Distance between the screen
and the center of the lens
Screen
size 40 60
(inches)
Minimum 1.6 2.4
Distance (5.2) (8.0) (10.8) (13.5) (16.3) (20.4) (27.4)
Maximum 2.0 3.1
Distance (6.7) (10.2) (13.7) (17.1) (20.6) (25.8) (34.5)
Note
You can not install the projector upside down, such
as on a ceiling.
14
(GB)
Unit: m (feet)
80 100 120 150 200
3.3 4.1 5.0 6.2 8.3
4.2 5.2 6.3 7.9 10.5

Connecting

Connecting with a Computer

This section describes how to connect the projector
with a computer.
For details on how to connect a VCR, 15k RGB, or
component equipment, see page 16 (GB).
When the projector is connected to a computer, you
can control the mouse of a computer by the Remote
Commander.
The R/L CLICK keys and joy stick function as
follows.
Note
Make sure that there is nothing to obstruct the infrared
beam between the Remote Commander and the
remoter control detector on the projector.
Function
Key and
a)
IBM PC/AT
joy stick
compatible, Serial
R CLICK
Right button
(front)
L CLICK
Left button
(rear)
Joy stick Corresponds with the movements of the mouse
a) IBM PC/AT is a registered trademark of International
Business Machines Corporation, U.S.A.
Also refer to the instruction manual of equipment to
be connected.
Notes
• This unit accepts the VGA, SVGA, XGA, and
SXGA signals. However, we recommend you to set
the output mode of your computer to the XGA mode
for the external monitor.
• If you set your computer, such as a notebook type
IBM PC/AT compatible, to output the signal to both
the display of your computer and the external
monitor, the picture of the external monitor may not
appear properly. In such cases, set the output mode
of your computer to output the signal to only the
external monitor.
For details, refer to the operating instructions supplied
with your computer.
Macintosh
Mouse button
Mouse button