Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in fluids entering your eyes resulting in possible serious
injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 Interior and exterior painting and staining of decks,
outdoor furniture, fences, and walls
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator's
Manuals for your Ryobi One+ battery pack and charger
models.
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries are designed with features that
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 12.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Place the battery pack in the tool. Align the raised rib on
the battery pack with groove in the battery port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.

OPERATION

To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use or carrying
at your side.
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
FILLING SPRAYER WITh PAINT/STAIN
See Figures 3 - 4, page 12.
Remove and discard any skin that has formed on top of the
paint or stain, then thoroughly mix the material in its original
container before beginning.
NOTE: Older containers of stain and paint may need to be
strained before use.
 Remove the battery pack from the sprayer.
 Remove the quick-lock container by twisting counter-
clockwise so that the arrow on the container lines up with
the "unlock" symbol on the lid.
 Fill the container with paint or stain as desired. Do not fill
above the max fill mark on the container.
 Reinstall the container on the sprayer and twist clockwise
so that the arrow on the container lines up with the "lock"
symbol on the lid.
SELECTING ThE PROPER SPRAY TIP
See Figure 5, page 13.
To switch tips:
 Remove the battery pack from the sprayer.
 Remove the installed tip by turning it counter-
clockwise.
 Install the desired tip and rotate clockwise to tighten
securely.
NOTE: The tip should be tightened securely by hand. A
too loose or overtightened tip may cause the sprayer to
leak or be damaged.
8 — English
Use the 1 in. round fan tip for latex paints and
stains. This tip sprays in a round pattern.
Use the 12 in. wide fan tip for latex paints, oil-based
paints, and stains. This tip sprays in a wide pattern
that can be adjusted from horizontal to vertical.

Publicidad

Tabla de contenido
loading

Tabla de contenido