Publicidad
Idiomas disponibles
Idiomas disponibles
This fountain can be used with a variety of chocolates or sauces.
Depending on your taste, you can use milk chocolate, dark
chocolate, white chocolate, butterscotch to dip fruit pieces,
marshmallows, cookies etc.
BEFORE THE FIRST USE
Remove all packaging material and wipe out the base bowl with
•
a damp cloth and dry. Make sure no water penetrates in the
motor unit.
Clean the auger and the tower with soapy water, rinse and dry
•
thoroughly.
ASSEMBLY
Make sure all switches are in OFF position and that the appliance is
unplugged before assembling.
Never attempt to place the auger or the tower on the base while the
motor is running.
To assemble the appliance, put the auger on the axle in the center
of the bowl, and pass the tower over the auger, making sure that the
three openings on the bottom of the tower fit in the three pins in the
center of the bowl.
To work properly, the surface must be level. If it is not totally level, you
can adjust the position of the appliance by turning the height
adjusting screw in the adequate direction.
HOW TO USE
Once the appliance is correctly assembled, plug it into a wall
•
socket.
To start, turn the right switch (4) to activate the heater. The pilot
•
light goes on, indicating that the appliance is heating.
Let the unit warm up for at least 3 to 5 minutes before adding the
•
melted chocolate.
In the meantime, prepare the chocolate as follows:
•
Combine 1.7lbs of chocolate chips with 1 cup of cooking oil in a
microwave safe bowl. Place bowl in microwave, and heat for 2
5
USK CHM 1 - 060327
Publicidad
