Descargar Imprimir esta página

RIDGID R40211 Manual Del Operador página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the bevel table and feed
the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
ADJUSTMENTS
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the OFF position. Failure to heed this
warning could result in serious personal injury.
The saw has been adjusted at the factory for making very
accurate cuts. However, some of the components might
have been jarred out of alignment during shipping. Also,
over a period of time, readjustment will probably become
necessary due to wear.
Do not start any adjustments until you have checked with
a square and made test cuts to be sure adjustments are
needed.
ALIGNING THE RIP GUIDE WITH THE
CUTTING WHEEL
See Figure 23.
For the most accurate results, the rip guide must be aligned
with the cutting wheel.
 Unplug the saw.
 Make sure the cutting wheel has been correctly installed
on the arbor and the arbor nut has been securely tight-
ened.
 Raise the splash hood.
 Slightly loosen the two screws on top of the rip guide.
 Position the rip guide scale at "0" on the side of the cut-
ting wheel.
 Lock the clamp.
 Carefully adjust the rip guide until it is just touching the
cutting wheel. Do not push against the wheel. Adjust the
guide until there are no gaps between the wheel and the
edge of the rip guide.
 Tighten the two screws on top of the rip guide.
20 — English
BEVEL CUT
CUTTING
GUIDE
WHEEL
SCREWS
Fig. 22
RIP
Fig. 23

Publicidad

loading

Este manual también es adecuado para:

R4021R40211cn