Klarstein WONDERWALL SMART 1200 Manual Del Usuario página 16

EN
16
WALL MOUNTING INSTRUCTIONS
Mark the positions of the four holes to
be drilled on the wall, and Drill the holes
with the drill bit. Make sure the distance
between each holes is same as the round
holes on the brackets at back of the
heater.
Insert the plastic rails fitting into the
holes.
Insert the metal screws into the plastic
rails.
Lift the heater and aim the four round
holes on the brackets at back of the
heater to the 4 screws on the wall.
Slide the screw from Position A to
Position B by moving the heater slightly.
Make sure the distance between the
bottom of the heater and the floor is
no less than 20 cm when the heater is
installed.