Publicidad
Idiomas disponibles
Idiomas disponibles
EN
18
OPERATION
Getting Started
1. Check the heater to be sure it is not damaged.
2. Insert the plug in the socket
3. Turn the main switch on: the light will turn on and the heater is in standby mode
4. Now press the ON/OFF switch: the heater will start working. The display will show
the room temperature.
5. Press the ON/OFF button first in order to switch the device off. The heater is now
in standby mode. Now switch the main switch off (O); the lamp will go out. Finally
remove the plug from the socket.
Thermostat
1. If you press the + or - key, the temperature setting will flash 5x on the display.
2. You can adjust the temperature setting by pressing the + or - key while it is flashing.
With each key press, the temperature will be increased (+) or decreased (-) by one
degree.
3. The device will retain the temperature setting by switching itself on and off
automatically.
Timer
• Briefly pressing once on the M button will switch the timer on. The red timer lamp
will burn and the display will blink.
• You can set the time when the heater is to switch itself off by pressing the [+] or [-]
buttons: with each press it will go an hour forwards or backwards. The timer time is
set after 5x unchanged blinking.
• The display will now alternately show the room temperature (red lamp off) and the
set number of hours (red lamp burning). The display will then go off.
• The heater will switch itself off after the set number of hours.
WiFi Reset
• Press and hold the M button for 5 seconds until you hear the beep; the WiFi setting
will reset and the blue light will flash rapidly (twice per second).
Note: The display will switch off if you change nothing in the settings for 10 seconds.
You can reactivate it by pressing once on any button at random.
Publicidad
