Personnel Qualifications; Safety Instructions - Aventics VTM Instrucciones De Servicio

AVENTICS | VTM | R402002668-BDL-001-AC
3.3

Personnel qualifications

Installation, connection and commissioning require fundamental
knowledge of electronics and pneumatics, as well as knowledge of
the applicable technical terminology. For this reason, the device
may only be installed, connected and commissioned by a specialist
in electronics and pneumatics or by a person under the control and
supervision of such a specialist.
Qualified personnel are those who can recognize possible hazards
and institute the appropriate safety measures due to their
professional training, knowledge, and experience, as well as their
understanding of the relevant conditions pertaining to the work to
be done. Qualified personnel must observe the rules relevant to
the subject area.
3.4

Safety instructions

In this document, there are safety instructions before the steps
whenever there is a danger of personal injury or damage to the
equipment. The measures described to avoid these hazards must
be followed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of risk
Consequences
Precautions
O
Safety sign: draws attention to the risk
W
Signal word: identifies the degree of hazard
W
Type of risk: identifies the type or source of the hazard
W
Consequences: describes what occurs when the safety
W
instructions are not complied with
Precautions: states how the hazard can be avoided
W
31
For your safety