Measurement With Valve Control Box - Aventics VTM Instrucciones De Servicio

40 AVENTICS | VTM | R402002668-BDL-001-AC
Instructions
Limitations
In the example above, initially the right-hand sensor is low and the
left-hand sensor is high. The meter waits for the cylinder to begin
its plus motion so that the left-hand sensors goes low and timing
can start. At the end of the stroke, the right-hand sensor goes high,
measurement ends and the time difference between the two
flanks is displayed.
The longest possible measuring time is 60 seconds.
7.4

Measurement with valve control box

Return 0 Start
4
5
Fig. 7: Valve control box connected to cylinder via a valve
1. Apply the sensor to the cylinder (1).
2. Connect the M8 cable between the box and the "Start"
connector of the meter (2).
3
2
Reset Cal.
Enter
Velocity-Time-Meter
1
00123803