6
Operating Instructions
W a s h C y c l e S e l e c t i o n s
Cycle times are approximate and vary by options
selected. Hot water is necessary to activate
dishwasher detergent and melt fatty food soils.
An automatic sensor checks the water temperature
for the main wash of each cycle. When HI-TEMP
is selected, the sensor checks for an even higher
temperature. Run hot water in a faucet nearest the
dishwasher until water is hot before starting.
C y c l e S e l e c t i o n s
The Smart Sensor checks the soil level on your
dishes in the Auto, Normal and Eco cycles. Cycle
time and water usage will vary based on the
amount of soil on the dishes.
Auto
The dishwasher's Smart Sensor technology will
determine the type of cycle required to clean the
dishes and will clean more effi ciently every time.
When a partial load of lightly soiled dishes are
placed in the unit, a wash cycle similar to a short
wash will automatically be performed. When a full
load of heavily solid dishes is placed in the unit, a
heavy wash cycle will automatically be performed.
Water usage ranges from approximately 3.0 to 7.4
gallons. Wash time ranges from approximately 118
to 200 mins.
Heavy
For pots, pans, casserole dishes and dinnerware
with dried-on or baked-on soils. Water usage
ranges from approximately 7.1 to 8.1 gallons.
Wash time ranges from approximately 129 to 189
mins.
Normal
For regularly soiled dishes and silverware. Water
usage ranges from approximately 3.0 to 7.4
gallons. Wash time ranges from approximately 118
to 200 mins.
Rinse
For rinsing dishes that will be washed later. Water
usage is approximately 2.2 gallons. Cycle time is
approximately 15 mins.
Fast
For regularly soiled and pre-rinsed dishes and
silverware. Water usage is approximately 4.5
gallons. Wash time is approximately 30 mins.
E n e r g y O p t i o n S e l e c t i o n s
Hi-Temp
When HI-TEMP option is selected, the dishwasher
heats water in the main wash to approximately
140
0
F (60
0
C).
This increase in water temperature helps
dishwasher detergent remove food, grease and soil
from dishes more effectively and aids in drying. HI-
TEMP option can only be used with AUTO, HEAVY,
and NORMAL cycles.
Sanitize
To sanitize your dishes and glassware, select the
SANITIZE option. This option heats the water
temperature in the fi nal rinse to 157
and maintains that temperature for 7 minutes.
SANITIZE is available in Auto, Heavy, and Normal
cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120
0
F (49
0
C).
If the SANITIZE option is selected, the led above
the pad comes on. The sanitization criteria may
not be satisfi ed if there is an interruption of the
cycle, a power failure occurs, or if incoming water
temperature is below 120
Sanitize led fl ashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
0
F (69.4
0
C)
0
F (49
0
C).