Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Make sure cords have enough slack to allow full movement of the arm.
5
Route cords inside arm slots of wall mount (A) as shown in figure 5.1. Optional: Run power cord through one side of
mount and signal cable(s) through other side in order to avoid interference with the signal.
Lock cords into place by sliding cord covers onto mount as shown in figure 5.2. Screen may have to be moved for
better access for sliding on the cord covers.
fig. 5.1
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the
screen to fall.
If more or less tension is desired in the arm pivot points, do the following:
6
• To increase tension, turn tension screw(s) clockwise with allen wrench.
• To reduce tension, turn tension screw(s) counter-clockwise with allen wrench. Do not turn more than half a turn.
A
WARNING
TENSION SCREWS
CORD COVER
fig. 5.2
Publicidad
