Makita RT0700C Manual De Instrucciones página 10

Screw a bar type grip (optional accessory) onto the grip
attachment.
011984
In another way of use, the knob type grip which is
removed from a plunge base (optional accessory) can
be installed on the grip attachment. To install the knob
type grip, place it on the grip attachment and secure it
with a screw.
011986
When using as a router only with a plunge
base (optional accessory)
CAUTION:
When using as a router, hold the tool firmly with
•
both hands.
1
011855
To use the tool as a router, install the tool on a plunge
base (optional accessory) by pressing it down fully.
Either knob type grip or bar type grip (optional
accessory) can be used according to your work.
1. Screw
1 2. Knob type grip
3. Offset base plate
2
3
1. Plunge base
2. Grip
2
011856
To use the bar type grip (optional accessory), loosen the
screw and remove the knob type grip.
011857
And then screw the bar type grip on the base.
Adjusting the depth of cut when using the plunge
base (optional accessory)
1
2
3
4
5
6
7
011983
Place the tool on a flat surface. Loosen the lock lever
and lower the tool body until the bit just touches the flat
surface. Tighten the lock lever to lock the tool body.
Turn the stopper pole setting nut counterclockwise.
Lower the stopper pole until it makes contact with the
adjusting bolt. Align the depth pointer with the "0"
graduation. The depth of cut is indicated on the scale by
the depth pointer.
While pressing the fast-feed button, raise the stopper
pole until the desired depth of cut is obtained. Minute
depth adjustments can be obtained by turning the
adjusting knob (1 mm per turn).
10
1. Screw
2. Knob
1
2
1. Bar type grip
(optional
accessory)
1
1. Adjusting knob
2. Lock lever
3. Depth pointer
4. Stopper pole
setting nut
5. Fast-feed button
6. Stopper pole
7. Stopper block
8. Adjusting bolt
8