Makita RT0700C Manual De Instrucciones página 7

1
2
3
4
001990
Attach the straight guide with the clamp screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
1
2
3
011841
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight guide
cannot be used. In this case, firmly clamp a straight board
to the workpiece and use it as a guide against the trimmer
base. Feed the tool in the direction of the arrow.
A
011842
Circular work
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows:
Min.: 70 mm (2-3/4")
Max.: 221 mm (8-11/16")
For cutting circles between 70 mm (2-3/4") and 121 mm
(4-3/4") in radius.
1. Bolt
2. Guide plate
3. Straight guide
4. Wing nut
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
4
1
4
5
001993
For cutting circles between 121 mm (4-3/4") and 221
mm (8-11/16") in radius.
1
4
5
001994
NOTE:
Circles between 172 mm (6-3/4") and 186 mm
•
(7-5/16") in radius cannot be cut using this guide.
Align the center hole in the straight guide with the center of
the circle to be cut. Drive a nail less than 6 mm (1/4") in
diameter into the center hole to secure the straight guide.
Pivot the tool around the nail in clockwise direction.
011843
Trimmer guide (optional accessory)
011844
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the clamp
screw (A). Loosen the clamp screw (B) and adjust the
7
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
1. Nail
2. Center hole
3. Straight guide
1
2
3