Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
READ AND SAVE THESE INSTRUCTIONS. Failure to
follow all instructions listed below, may result in electric
shock, fire and/or serious personal injury.
WARNING:
Follow all safety instructions recommended by the drill
manufacturer.
Save all warnings and instructions for future reference.
The term "product" in the warnings refers to your mains-
operated (corded) product or battery-operated (cordless)
product.
WORK AREA SAFETY
Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
Do not operate products in explosive atmospheres,
such as in the presence of flammable liquids, gases
or dust. Products create sparks which may ignite the
dust or fumes.
Keep children and bystanders away while operating
a product. Distractions can cause you to lose control.
ELECTRICAL SAFETY
Risk of explosion or fire. Never pump flammable or
explosive liquids such as gasoline or kerosene.
Disconnect the drill from the pump when not in use.
Unplug the drill or remove the drill battery before
attempting to service the pump.
Risk of electric shock. Keep hands, feet, and drill dry.
Using a wet drill could result in fatal electric shock.
Risk of electric shock. When operating with an AC
powered drill, ensure it is always grounded to an
acceptable electrical outlet. Use only double insulated
drill or a drill with a 3-wire grounded power plug. Always
connect drill to an outlet equipped with ground fault circuit
interrupter (GFCI) protection.
PERSONAL SAFETY
Do not overreach. Keep proper footing and balance
at all times. Proper footing and balance enable better
control of the product in unexpected situations.
Do not use on a ladder or unstable support. Stable
footing on a solid surface enables better control of the
product in unexpected situations.
IMPORTANT SAFETY INSTRUCTIONS
Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to power source
and/or battery pack, picking up or carrying the tool.
Carrying power tools with your finger on the switch or
energizing power tools that have the switch on invites
accidents.
DRILL PUMP USE AND CARE
Check hoses before using pump. Replace if worn or
damaged.
Ensure all hose connections are tight before using pump.
CAUTION: The pump has been evaluated for use with
water only. Do not use with acids, alkalines, solvents,
flammable material, gasoline or petroleum products,
bleaches or industrial grade solutions. These products
can cause physical injuries to the operator and irreversible
damage to the pump.
Disconnect the drill from the pump before making
any adjustments, changing accessories, or storing
the product. Such preventive safety measures reduce
the risk of starting the product accidentally.
Release the pressure and drain water from the pump
before servicing or before putting in storage.
Keep the product and its hose dry, clean and free from
oil and grease. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based
products, or any strong solvents to clean your product.
Following this rule will reduce the risk of loss of control
and deterioration of the enclosure plastic.
Clean only with dry cloth.
Do not operate near any heat sources such as radiators,
heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
SERVICE
Product service must be performed only by qualified
repair personnel. Service or maintenance performed by
unqualified personnel may result in a risk of injury.
When servicing the product, use only identical
replacement parts. Follow instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance
Instructions may create a risk of shock or injury.
2 – English
Publicidad
