Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Not pumping water
Flow rate is too low
OPERATION
TROUBLESHOOTING
POSSIBLE CAUSE
Impeller blockage.
Outlet line positioned
too high.
Outlet line is too long.
Inlet/Outlet line is
clogged or damaged.
Inlet connection not
air tight.
Impeller cover is not
secured tightly.
Impeller worn out.
7 – English
POSSIBLE SOLUTION
See Replacing the Impeller and O-Ring in the Maintenance
section of this manual.
Lower the outlet hose height to below the height listed in the
Product Specifications.
Use a shorter length of outlet line if possible.
Replace Inlet/Outlet line. Check lines for blockages, kinks or
bends. Clear blockages.
Tighten inlet connection. Add pipe thread tape or a gasket if
necessary.
Hand tighten four (4) cover screws.
See Replacing the Impeller and O-Ring in the Maintenance
section of this manual.
Publicidad
