Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Always install the hoses before operating the unit.
Grip the intake hose to prevent any rotation due to
starting/stopping torque.
Squeeze the switch trigger to start the drill.
WARNING:
Firmly hold the intake hose with a gloved hand while in
operation.
To stop the pump:
Release the switch trigger of the drill.
Remove the drill's battery, or disconnect the drill's power
supply.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
STORING THE DRILL PUMP
Store indoors in a dry, locked-up place out of the reach of
children, with the pump disconnected from the drill and all
hoses. Keep away from corrosive agents such as garden
chemi cals and de-icing salts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
OPERATION
PRIMING THE PUMP
See Figure 6.
Add water to the water inlet side of the pump to prime
the impeller.
NOTE: For best results, add water to the inlet to prime
the pump. This step is not necessary but it will speed up
the priming process.
Slowly start the drill, bringing it to full speed within a few
seconds. The pump should self-prime within 10 seconds.
NOTE: If the pump does not prime, make sure there are
no obstructions or leaks in the inlet hose.
MAINTENANCE
REPLACING THE IMPELLER AND O-RING
See Figures 7 - 8.
Disconnect the pump from the drill and hoses.
Locate and remove the four screws from the impeller
plate cover.
Carefully remove pump cover and inspect o-ring for
damage or wear. If o-ring is damaged or worn,
replace o-ring.
NOTE: Be sure to keep the pump cover and glass plate
together in the same order for installation.
Remove old impeller and replace with new impeller,
lining up the key on the shaft. After insertion, the impeller
should be resting flat against the back wall of the pump
body, as the original impeller was.
Make sure o-ring is properly seated and assemble pump
cover and glass plate.
Assemble the four screws and hand tighten only. Refer
to Starting/Stopping the Drill Pump and check to make
sure the impeller plate does not leak.
Register your product: www.ryobitools.com or
This product has a One-year Warranty.
6 – English
call toll-free 1-800-525-2579
Publicidad
