Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
When using with an AC powered drill, always ensure
the drill is properly grounded and plugged into a GFCI
protected outlet.
WARNING:
Risk of electric shock, serious personal injury, or death.
When connected to a drill, never touch pump with wet
hands or when standing on a wet surface.
WARNING:
Keep water discharge pointed away from all electrical
devices to reduce the risk of electrocution or electric
shock.
WARNING:
Ensure all hose connections are secure before using the
drill pump. Spilled water and leaks can result in a slippery
surface and create a slip and fall hazard.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Always remove battery pack or unplug power cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging power cord will
prevent accidental starting that could cause serious
personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
Drain or remove water from flooded areas, clogged
sinks, water basins, water heaters, swimming pools,
etc.
OPERATION
ASSEMBLING THE DRILL PUMP
See Figures 2 - 4.
WARNING:
Do not use a drill that exceeds 2,800 max RPM.
The drill pump connects to an electric drill, cordless drill or
impact driver using a 1/4 in. hex shank connection.
Remove battery pack or disconnect the drill from a power
supply.
Inspect the gasket in the suction hose to ensure it is in
good condition and properly installed in the hose.
Follow the steps in Priming the Pump section for best
priming results.
Connect the supplied suction hose to the water inlet on
the pump.
Connect a heavy duty garden hose to the water outlet on
the pump.
Attach the drill pump and connected hoses to the drill.
Tighten the drill chuck onto the bit located on the back
of the pump.
PREPARING THE PUMP FOR USE
See Figures 4 and 5.
Inspect hoses prior to use to be sure both are in good
condition and are securely connected.
Make sure the intake hose is submerged in the liquid and
is air tight.
Direct the discharge hose away from the area being
pumped or into a suitable container.
Make sure the direction of rotation of the drill is in the
forward setting.
NOTE: When drill operates in reverse, the suction and
outlet are reversed.
Ensure the intake hose is not pinched or kinked.
NOTE: Firmly grasp the drill in one hand and the intake hose
in the other while the pump is in use.
STARTING/STOPPING THE DRILL PUMP
See Figure 5.
To start the pump:
Insert the drill's battery or connect the drill to a power
supply.
WARNING:
Battery tools are always in operating condition, therefore
the unit should always be in the OFF position, with the
battery pack removed, when not in use. Do not leave
pump on while unattended. Failure to follow these
instructions could result in serious personal injury.
5 – English
Publicidad
