EINHELL EURO 2500-1 Manual De Instrucciones página 11

Anleitung Euro 2500-1 Einhell
Smoking is prohibited during to any pressure-bearing walls,
the spraying operation and in resulting in them being taken
the work room. Paint vapours out of operation in accordance
are highly flammable. with Section 13 Paragraph 3 of
Make sure there are no open the German Pressure Vessel
fires or open lights in the work Act, the operator has to notify
room. Sparking machines are the supervisory authorities and
discuss what action is to be
not to be used.
taken.
Do not keep or consume food
and drink in the work room.
Putting the compressor
Paint vapours are harmful.
The work room has to be
into operation
bigger than 30 m 3 and have
sufficient ventilation for
Assembling the wheels (1):
spraying and drying. Never
Fit the wheels as shown in
spray into the wind.
Figure 1.
It is always imperative to
1
observe the regulations of your
local police authorities when
spraying combustible or
hazardous substances.
Never process media such as
white petroleum spirit, butyl
alcohol and methylene chloride
with the PVC pressure hose
(reduced life span).
Operation of pressure
vessels in accordance Assembling the rubber buffer
Fit the supplied rubber buffer to
with the pertinent
the support foot as shown in
pressure vessel
Figure 2.
regulations
2
(e.g. Section 13 of the German
Pressure Vessel Act)
1. An operator of a pressure
vessel is required to keep the
pressure vessel in good
working order, to operate it
properly, to supervise its use,
to carry out essential
maintenance and repair work
immediately, and to introduce
essential safety measures
Replacing the oil filter and
according to requirements.
installing the air filter (fig. 3)
2. The supervisory authorities
Use a screwdriver to remove the
may order essential safeguards
oil filler plug and insert the
from case to case.
supplied stopper (2) in the
3. A pressure vessel may not be
opening.
operated if it has any defects
Important! Check the oil level.
which constitute a danger to
Screw the air filter (1) into the
employees or third parties.
hole in the side of the compressor
4. If pressure vessels of groups
pump.
III, IV, VI and VII suffer damage
21.07.2003 7:16 Uhr Seite 11
3
Connecting to the power
supply:
The EURO 2500 compressor is
equipped with a power cable and
an earthing-pin plug for
connection to any 230 V ~ 50 Hz
earthing-contact socket outlet with
a 16 A fuse. Long supply lines,
extensions, cable reels and
similar cause voltage dips and
may prevent the motor from
starting. Sluggishness makes
starting difficult at low
temperatures under freezing
point (0°C).
Explanation of the compressed
air fittings
1 Pressure switch
2 Safety valve
3 Pressure gauge (to indicate the
vessel pressure)
4 Pressure gauge (to indicate the
set pressure)
5 Pressure reducing valve
(pressure setting)
6 On/Off switch
4
GB
11