Uline TORNADO H-10400 Manual Del Usuario página 7

DAILY
Clean the roller brush.
WEEKLY
Check the roller brush for wear.
NOTE: The degree of wear can be determined
by comparing the differently colored indicator
tufts. Replace the roller brush when the black
bristles are the same height as the red bristles.
CLEANING THE ROLLER BRUSH
1. Remove the brush cover if necessary. Use a coin to
turn the rotary lock by 90° and remove the brush
cover.
2. Cut off hair and threads wound onto the roller brush
using scissors and remove them.
CHANGING THE FILTER BAG
1. Unlock and remove the filter cover.
2. Turn the filter bag lock to the right to unlock. Close
the filter bag, remove and dispose of it.
(See Figures 13-15)
Figure 13
Filter Bag Lock
Figure 14
PAGE 7 OF 28
MAINTENANCE
3. Insert a new filter bag and turn the filter bag lock
to the left to lock. (See Figures 16-17)
4. Fit and lock the filter cover.
REPLACING THE EXHAUST FILTER
1. Unlock and remove the filter cover.
2. Push the filter casing locking mechanism upward
and remove the filter casing.
3. Remove the exhaust filter from the filter casing.
4. Insert a new exhaust filter in the filter casing.
5. Insert the filter casing and latch it into place.
6. Fit and lock the filter cover.
Filter Bag
Lock
REPLACING MOTOR PROTECTION FILTER
1. Unlock and remove the filter cover.
2. Press the motor protection filter lock upward.
Remove old motor protection filter and dispose of it.
3. Fit and lock the new motor protection filter.
4. Fit and lock the filter cover.
Figure 15
Figure 16 Figure 17
0323 IH-10400